Tool control mark I is up and running! At the moment the three phase tools (table saw and planer thicknesser) are controlled by a keyswitch,
The ground is ready to receive an arduino in the clear lid box for a proper smart reader control! But hey ho, we have electricity in here now!!
Thanks a lot @joeatkin2
Tool control mark I
6 Likes
As you can see it was mostly made from scrap there’s still bits to come but should be up to version 1.1 with a tag reader soon
Yes, we do need the laser cutter working for this too
1 Like
The laser can run independently until the new members system is up and running.
We are going to have to sit down for figure out how fare we can go on the existing members system
How long will it take to move your software to a pi ?
And or how many control pins can we get out of the existing membership system and laser bot for the workshop
I meant to cut something.
1 Like
You have been out dislexiced again 
Sorry my stupid
Good job!!