Voron is throwing a “No trigger on probe after full movement” error on the first corner probe. It homes fine but then looks like it gets out to the front corner and doesn’t go low enough to hit the plate. Not sure if the Z offset is just out of whack, but nothing seemed out of the ordinary last night printing Roman’s pulleys.
Just to say it’s non-functional until it gets trouble-shot at some point.
Eh, it printed fine, I’ve cleaned it up with portable dyson vac and switched off, could I touch some wiring?
Is this happening on the main z home (pin) or the quad gantry(bed)? If it’s the quad gantry. If The gantry is too far out of square manually adjust the belts and retry
Fixed. Gantry had gone too far out of square. This is an easy/common fix so if thoese inducted want to know grab a tech when you see them.