Noticed an issue with the table saw yesterday, after stopping it with the estop pedal the saw wouldn’t start again until I hit the pedal a few more times to unstick it
May need a replacement pedal, or some maintenance @woodtechs
3 Likes
I’ll take a look today, cheers. Was it definitely stuck or is there a chance it was the time-delay on the e-brake stopping you from turning it on?
Don’t think it was the time delay, must have been a couple of minutes of me setting up my next cut etc.
1 Like
Investigated the fault - there was a bit of dust inside the stop so we suspect a bit got into the contact. We’ll keep an eye on it. Thanks for reporting the issue.
4 Likes
Dust really should not get into those!
If the problem reappears, I would suggest a sealed one like this.
3 Likes