Outside Table

Projects
1

Hi all,

First post here,

I want to join the club and do my first project. Im thinking of a small hip height out-door table to place a book or a glass.

I am thinking I would need to use the wood lathe. What is the process to get inducted and get started on this?

Thanks

2

Hi Pedro,

Welcome to our community. Have you had a chance to fill in our pre-membership survey from the Chatty Cathy message here on Discourse? That’s the fastest and easiest way to become a member.

If you’re around next Wednesday, there will be an Open Evening between 7pm and 9pm, no RSVP just come by and take a look, have a chat.

See you at the Makerspace,
Mark

3

Hi Mark,

I have already been to one of the Open Evenings and I am super keen in joining. I filled the pre-membership survey. What do I do next?

Thanks,
Pedro

4

Once you join, you need to do a basic woodshop induction first, quite frequent: on the 25th and 26th of October so far. Wood lathe inductions are quite frequent too, with @dario , who just installed a brand new one.

1 Like
5

Hi Pedro,

We have sent you an invitation to join the Makerspace Tuesday, 14 October. This was sent to your e-mail you provided in the pre-membership survey. Please make sure to check your spam folder, if you haven’t yet.

Let us know if you can’t find it. The subject is “Membership Invite to the Makerspace” and the sender is info@southlondonmakerspace.org.

All necessary information to join is in that e-mail.

See you at the Makerspace,
Mark