Works been getting properly in the way of play but i’m up for a session of solder and flux smoke tonight… whos about then ?
Will bring @boldaslove tape with me + a few ESP’s and sensors etc
Courty
Electronics night - 15th Sep
2 Likes
Will be there
Was going to go climb for a couple of hours, but might drop in on the way home c.9pm
2 Likes
I am planning to be there.
Sorry guys, not going to make it tonight. My father in law just took a tumble. Need to look after the kids… 
Courty
Sorry to hear that. I hope he makes a speedy recovery. Also I would like to find out more about your little man in China. I have one design ready and Joe and Pip are cooking another one.
1 Like
Sorry to hear that hope he is ok
1 Like
Appols All, Father in law is out of hospital now with a couple of busted ribs, not good when your in your 80’s…
@dsikar, @joeatkin2, @pip are you designing in Eagle 7.x ? If so I have a full set of CAM Processors in my copy that spits out the manufacturing files for my man Ted in China (that one of the reasons I get a discount!).
If this is good to go let me know and I’ll PM you my email address, you send the brd and sch files over and i’ll do a quick check, process the files and send them off to get a quote.
Courty
2 Likes
Ouch. Had that a couple month’s back. Not a wink of sleep three nights in a row.
On the pcb front, thanks! My files were done in an earlier version so I opened them in eagle 7.6 then saved again, hope it works:
1 Like
No I did it in easy pcb . And set up the bord for home etching .
Good to hear that you father in law was ok 
1 Like
Put your boards through the renderer - couple of queries that ive mailed you but looking good !!!
Courty
I like it!