Starting up the bambu today and noticing a few new scratches on the plate. Or at least I didn’t notice them last week. Thankfully not right at the center of the plate.
Bambu plate scratches
The plate was also seated 90 degrees off and not indexed to any corners.
These scratches shouldn’t affect any prints though please all be careful with this @3dprinters . The cool plate has a replaceable surface and will wear over time. The longer we can make it last though the better.
Hey,
I ran a small test print last night but I didn’t need to use any tools that would have scratched the plate, I just popped the print off by flexing the plate.
I take full responsibility for not putting it back correctly though. I’ll pay closer attention to alignment and orientation. Apologies for this.
1 Like