Any experienced Babmu studio/ 3D printers could help slicing + reviewing my 3D printing file?

#1

Hello 3D printers,

I’ve got a file I want to print off, but I was wondering if anyone might be around in the day on Saturday, when I plan to be in, to help me resolve some small issues/ cast an eye over the finished project to check it’s set up in the most efficient way. Would hate to waste hours of time + muchos filament on an amatuerish setup.

I wouldn’t think it would take much more than 10 minutes! Once it’s done I’ll start booking in time on the printer. FWIW I’m wanting to print off a scan of a sculpture to make a plaster casting of it.

Thanks :slight_smile:

#2

Sure!

1 Like
#3

cheers! seeya then

#4

I’ll be in around 1 - 2ish

1 Like
#5

perfect, same

#6

Hi Neil, apologies but I’m not able to come down to the space until much later if at all today. So if we cross paths we can chat, otherwise will have to catch you another day! Thanks for letting Dan know about my project as well. Cheers :slight_smile:

#7

I’ll be around for a while today working on my bike trailer a bit

1 Like