Rubber - Laser cutter

Discussion
1

Hi,

I would like to cut some thin rubber sheet, it says this is a material that can be cut on the trotek site: http://www.troteclaser.com/en-US/Materials/Pages/Rubber.aspx

It is not on the banned, or allowed list so as long as I take the usual precautions is this okay?

cheers
Tim

2

Are you making stamps? That’s something I’d like to try too.

3

I want planning on it but that is the example it gives on Troeks site.

4

Let me know when you are doing iti would like to watch if i am about

5

I did it the other day. I have some if people want to buy some off me. Trotec only sell it in 10 packs.

6

Any rubber still up for grabs @unknowndomain?

7

Yeah, I just need to figure out a fair cost, or I can buy it from work for £11 for an A4 sheet.

8

How about the cost of 10 sheets divided by ten :wink: Or £11 for a sheet also fine. I’m in no huge rush just let me know when / what’s good for you.