Is there a reason why the laser cutter has been disconnected from the computer?
@lasers ?
When I walked past it this morning there were bits like the power supply on the top of it, looked like someone had been working on it.
Which is why we need to know who has done this. Was it cleaning and they ran out of time?
Is there a fault?
Why was there not at least a note on it explaining what has happened?
Can we put it back together and use it?
I have no idea, I’m saying it was like that at 10:30 am when I walked past and there was no one tending to it.
Sorry my fault I osmoed the wood meant to say on my post about that last night for who ever was in this morning to put it back together, apologies.
All up and running again and when the osmo dries the computer can sit on that little shelf I’ve put up. Raised the monitor too!
3 Likes
Thank you @lewisss for pointing this out 
2 Likes
Uh, can the cutter still be slid out of its alcove for servicing? The pc shelf looks quite close…
Moon on a stick you. I’ll move it tomorrow when it’s dry.
1 Like
Too kind 